Features:

1.End trimming and trimming unit adopt imported high-motor, it is high precision, lower noise,long life,processing stability.
2.Adopt imported frequency converter,action is sensitive and reliable and with good stability.
3.The function including 6 function：preheating pressing ，gluing，end cutting，rough trimming，fine trimming scraping.
4.Machine frame: Welding frame adopts national standard 50 * 90 * 5 mm rectangular pipe square tube and bottom 40 * 80 * 5 channel steel welded frame structure, pre-milled table of heavy-duty gantry milling machine to ensure the flatness of the equipment and the whole machine plastic appearance Beautiful and not rusty.
5.The beams are all 18 mm thick high-quality high-strength ship plates. Sheet metal shells are 1.8-6 mm thick cold plates.

1. Pay attention to the sudden operation of the trimming knife to avoid personal injury. 2. When the profiling belt is loose, the trimming effect is rough; When the belt is tight, the belt will shake up and down and cannot be trimmed normally.
3. There is an air outlet in the middle of the "sheet stabilized air column" to make the sheet more smooth when trimming. Small or large air flow will affect the trimming effect.
4 Please wear goggles and earplugs when working.
The 514mm and above plates can be trimmed on both sides; For single side trimming of plates less than 14 mm, if double-sided trimming is required for plates less than 14 mm, please consult the manufacturer for adjustment or customization of accessories under the guidance of after-sales specialists.
6 When entering and exiting the plate, step on the trimming pedal synchronously, and then enter and exit the plate after opening and closing. 7. Pay attention to clearing the residual debris of the scraper. Too much residual debris will affect the scraping effect. 8. The turning speed of the profiling wheel refers to the trimming speed.
9. The profiling belt will not rotate until the trimming start stop device detects the plate.